Ghost Controls Keypad & Intercom Repair Nationwide

Ghost Controls Keypad & Intercom Repair: The Agoura Hills Owner’s Guide

Ghost Controls keypad and intercom repair in Agoura Hills typically runs between $140 and $380 installed, depending on whether we’re replacing the keypad face, the intercom board, or the entire unit. Most jobs are completed same-day because we stock Ghost Controls-compatible parts on the truck. The typical story we hear: the keypad stopped accepting the code after a rain, or the intercom works fine but nobody can hear the visitor through the speaker, or the buttons need three presses before one registers. You’re not imagining it. These components wear out, and in Agoura Hills, dust from the hillsides along Chesebro Road accelerates it.

Call (424) 388-2906

Which Ghost Controls Models This Applies To

Ghost Controls builds keypads and intercoms for the AXDP, AXP1, TSS1, TDS2, and HYDP series openers. The wireless keypad that pairs with these units is the AXWK model, and the wired intercom comes in two generations. The older generation uses a two-wire connection to the control board; the newer one rides on a four-wire harness with a separate ground. That distinction matters more than most people realize. We’ve been called out in Agoura Hills more than once after a homeowner bought the four-wire intercom for a two-wire opener, or vice versa, and the system refused to pair.

The identification is simple if you know where to look. Open the keypad cover and you’ll see a small white sticker on the inside of the faceplate with the model number. The intercom’s model is printed on the back of the speaker housing. If the sticker is faded from sun, we identify it by wire count and connector shape, which takes about two minutes. On OEM versus aftermarket: Ghost Controls OEM parts are well-built, but the aftermarket keypad from Linear’s compatible line costs roughly $40 less and holds up just as well in California sun. We stock both and will tell you the honest difference rather than steering you toward whichever one pads the invoice. Vance Gate Repair Agoura Hills is an independent service provider, not affiliated with Ghost Controls.

Key Takeaways

• Ghost Controls keypads come in wireless (AXWK) and the wired intercom has two generations with different wiring. Match before you buy.
• Failure in Agoura Hills is usually sun or dust related, not defect. Corrosion at the keypad ribbon cable is the number one culprit we find.
• We stock Ghost Controls-compatible parts on the truck and the typical installed repair ranges $140 to $380.
• Written price before work starts, photo record when we leave, 365-day promise if it’s not right.

Signs Your Ghost Controls Keypad & Intercom Repair Is Failing

• The keypad beeps but doesn’t accept the code on the first try, then works on the third. This is almost always micro-switch wear or a failing ribbon cable between the keypad face and the board. The contacts oxidize. Dust from Agoura Hills hillsides gets into the housing and coats the traces. A cleaning sometimes buys a few months; a board swap fixes it for years.
• Buttons work when pressed at the edge but not in the center. The silicone membrane under the faceplate has lost its rebound. Sun exposure through the housing breaks down the silicone, especially on south-facing gates.
• The intercom cuts in and out while someone is talking. Loose crimp connectors at the control board, not the intercom unit itself. The vibration from the gate opening and closing works the terminals loose over time.
• You hear a constant low buzz from the keypad even when nobody is pressing anything. A ground fault on the keypad wiring. It’s usually water intrusion at the conduit entry point. We find this constantly on Agoura Hills properties where sprinkler heads sit too close to the gate post.
• The keypad lights up but the gate won’t move, even though the remote works. The keypad relay has failed internally. The remote runs on a different circuit, so the gate still opens. People assume the opener is the problem. It’s not. The keypad board is the dead link.

Before

After

Replacement Cost & What’s Included

In Agoura Hills, a Ghost Controls keypad replacement runs $140 to $210 installed. The intercom replacement lands between $190 and $380 depending on whether it’s the two-wire or four-wire generation and whether the speaker housing needs to be replaced too. If both keypad and intercom have failed, which we see after lightning strikes or severe water events, the combined job typically ranges $300 to $480.

The price you’re quoted is the price you pay. Written down, handed to you before any tool comes out, per Haven Standard Clause 1. The quote includes the part, the labor, the wiring check, the programming of the new keypad code, and the photo record of what was found and what was installed. No surprise line items at the end. The part itself carries a one-year replacement through the 365-Day Done Right Promise. If the keypad fails again within that window, we come back and make it right at no charge. No argument, no fee, no expiration.

DIY or Call Us?

Here’s where we’re honest with you. A homeowner with a multimeter and patience can check three things on a Ghost Controls keypad: battery voltage (should be 12V, anything under 11.8V is suspect), wire continuity at the terminals, and whether the ribbon cable is seated fully. Those checks take fifteen minutes and might save you a service call. What goes wrong with DIY is programming. Ghost Controls keypads have a learn procedure that requires specific timing sequences with the opener’s control board, and the sequence order changed between the first and second generation boards. Get the sequence wrong and the opener can lock into a fault state that then requires a full reset. At that point, the $140 keypad replacement has become a $300 board recovery. We see this once or twice a month in Agoura Hills. If the diagnostics are vague or the keypad is more than seven years old, call us at (424) 388-2906 and we’ll diagnose it with the truck stocked for same-day resolution.

FAQs

Get Your Ghost Controls Keypad & Intercom Diagnosed Today

If your keypad is flaking out, your intercom is buzzing, or the gate only accepts the code on alternating Tuesdays, call (424) 388-2906. A live person answers, day or night, no voicemail maze. We’ll get your address, ask what the keypad is doing, and send a technician with the right parts. Adrian Vance keeps a notebook in the truck, and before we leave you’ll have a written summary of everything found, everything done, and every part number installed. Name what you found. Name what it costs. Name what you left behind. That’s how we work in Agoura Hills.

Written by Adrian Vance, Owner, Vance Gate Repair Agoura Hills at Vance Gate Repair Agoura Hills, serving Agoura Hills and nearby areas.